
Corrosion does not wait for a shutdown or a scaffold crew. Up2 Rope Access carries out rope access protective coatings on industrial steel and structures across Perth and Western Australia: surface preparation by water blasting, garnet blasting and mechanical rust removal, then the coating system the asset owner or paint manufacturer specifies.
Working on ropes means we can reach tanks, silos, vessels, pipe racks, conveyors, shiploaders and jetty structures without scaffolding the whole asset, so spot repairs and touch-ups get done where they are needed instead of waiting for a full repaint.
Most industrial coating failures start small: a scratch from installation, a weld joint that was never coated, or a patch of rust on the side of a silo. Left alone, they spread. Fixing them early on rope keeps the asset protected without the cost and downtime of scaffolding or a full repaint.
On new plant, such as a water treatment plant built from modules that are coated off site and welded together on site, the field joints and any transport or installation damage still need preparing and coating. We blast or mechanically clean those areas and apply the specified system, so the finished structure is protected end to end.
On mine sites, refineries, ports and processing plants we repair corrosion on tanks, vessels, conveyors, pipework and structural steel, often while the site keeps running, as part of our mining and industrial rope access work. Where part of a job can be reached from the ground or a platform, we do that too, so you deal with one contractor for the whole scope.
On many sites, inspectors find coating defects and report them, work packs are written and a crew is sent out weeks later. We can work alongside your coating or NDT inspection program and repair defects as they are found, where the site’s procedures allow it, cutting out much of the reporting, rework and double handling. Read more in our guide to industrial coating repairs by rope access.
Surface preparation is what makes a coating last, so we prepare each area to the standard the specification calls for and apply the coating system the asset owner or paint manufacturer has chosen. In Australia, AS 2312.1 is the guide used for selecting paint systems to protect structural steel against atmospheric corrosion.
Up2 Rope Access is based at 418 Murray St in Perth and travels across WA for industrial work. See all our rope access services.


Years of Experience
Quality Workmanship
Crew, Whole Job
Google Rated

Protective coatings are paint systems designed to protect steel and concrete from corrosion and wear, not just to look good. On industrial assets they are usually multi-coat systems chosen for the environment the structure sits in, applied over thoroughly prepared surfaces.
Rope access reaches high or awkward areas such as tank walls, silo sides, pipe racks and jetty structures without scaffolding the whole asset. That makes spot repairs and maintenance coating practical, and usually means less disruption to an operating site.
We use water blasting, garnet blasting and mechanical rust removal, depending on the surface, the coating system and what the site allows. The preparation is matched to the specification for the job.
Yes. Field weld joints and any damage from transport or installation can be prepared and coated on site by rope access, so the structure is fully protected before it goes into service.
No. If part of the scope can be reached from the ground or a platform, we can do that as well, so the whole coating job is handled by one crew.
We are based at 418 Murray St in Perth and work on industrial sites across Western Australia, including mine sites, ports and processing plants.





